Rgblink Driver 2A Quick Start User Manual download pdf

Driver 2A– Quick Start

Installation and cabling features

Rear Panel

Connections

Step 1-Mounting

Turn off or disconnect all equipment power sources.

Driver 2A Quick Start

Rev 1.0

Page 1 of 2

Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C

Tel: 00865925771197 Fax:00865925771202

Email: [email protected] http://www.rgblink.cn

Step 4-HDMI Input

VIEW SIZE THE WORLD

NOTE

This guide provides quick start instructions for an experienced installer

to set up and operate the Driver 2A.

For full installation, configuration, and operation details, please refer to

the Driver 2A user manual, which is available at www.rgblink.com.

Step 3-DVI Input

Use to input DVI from DVI player or

computer with DVI connector.

Nixie Tube

Step 5-Gigabit Copper Port

Can receive video signal from HD player,

DVD and computer.

Local Control Front Panel Operation

Can control the brightness of LED sending card, and

the nixie tube will display the brightness value.

Connect to LED screen through cable.

LED Indicator

Red: Power indicator, it lights when device has power

supply.

Green: Signal indicator, it lights when device has

signal input.

USB Control Port of Sending Card

User can connect PC via USB cable and

control sending card software.

Function Button

Button 2: Down key, can switch to the top level

brightness value.

Button 3: Up key, can switch to the next level

brightness value.

How to connect

Connect the HD player, DVD or computer to the

HDMI input interface with HDMI cable.

Connect the DVI player or computer with DVI

interface to the DVI interface with DVI cable.

Connect the computer to the USB control port of

sending card with USB cable.

Connect the receiving card of LED Display to the

Gigabit Copper Port with cable.

DVI Input Interface

Audio Input Interface

Switch

Gigabit Copper Port

HDMI Input Interface Power

Step 2-Audio Input

Connect to microphone or the device with audio

interface.

Step 6-Power

Plug in power cord which has IEC connector, Driver 2A

supports AC power from 85 to 264V, 50-60Hz, which

means world wide compatible.

Power On

Connect one end of the power with the device, the other

end into a socket, and push power switch to ON

position. Red power indicator light means the device

works normally.

USB control Port of

Sending Card

Nixie Tube

Function Button

LED Indicator

Operation Manual

1 2

Quick Start 1

Summary of Contents

Page 1 - Quick Start

Driver 2A– Quick StartInstallation and cabling featuresRear PanelConnectionsStep 1-MountingTurn off or disconnect all equipment power sources.Driver 2

Page 2

Driver 2A Quick StartRev 1.0Page 2 of 2Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.CTel:

Comments to this Manuals

No comments

Rgblink Driver 2A Quick Start User Manual

Browse online or download User Manual for Equipment Rgblink Driver 2A Quick Start. RGBLink Driver 2A Quick Start User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Rgblink Driver 2A Quick Start